TM 10-3835-223-13&P
4-27. HYDRAULIC MOTOR AND DRIVE WHEEL MAINTENANCE -cont.
e.
Installation.
(1)
Position drive wheel (18), hydraulic motor (1) and attaching parts in frame
weldment (11).
(2)
While positioning four washers (5,6,7, and 8), push pivot rod (4) through drive arms (10
and 19) and frame weldment (11). Install cotter pin (9).
(3)
While positioning two washers (16 and 13), install pivot rod (12) through side arms (10
and 17) and cylinder clevis (14). Install cotter pin (15).
NOTE
Hydraulic hose (3) is black (no white sleeve) and has a male quick disconnect
fitting at one end.
(4)
Remove caps from hydraulic hoses and plugs from motor. Connect hydraulic hoses (2 and
3) to hydraulic motor (1) as marked.
(5)
Remove tags.
(6)
Install lower cylinder side guards (reference para. 2-20).
4-52