TM 10-4130-237-14
4-14.
COMPRESSOR DRIVEBELT REPLACEMENT (CONT)
b. Inspection (Pulley Drive)
1 With belt removed, inspect pulley drive or centrifugal clutch for wear and damage.
2 If pulley drive or centrifugal clutch is worn or damaged, replace it (para 416 or 417).
c. Installation and Adjustment
1 Install drivebelt on pulley drive and compressor pulley.
2 Push down on compressor, sliding bracket mounting bolts down in holes.
3 Adjust drivebelt to proper tension, about l/4-inch (2/3-centimeter) deflection at center of belt.
4 Tighten two bracket mounting bolts.
5 Install water pump drivebelt (para 4-13).
4-15.
FAN ASSEMBLY REPLACEMENT
This task covers:
a. Removal
INITIAL SETUP
Equipment
Condition
P a ra
Condition Description
48
Engine stopped, power
disconnected, fuel line
disconnected, muffler and
b. Installation
Tools
General Mechanics Tool Kit,
item 1, appendix B
4-19
housing removed.
Engine removed.
4-25