TM 10-4320-345-13
2-11. ASSEMBLY AND PREPARATION FOR USE-cont.
m. Assemble Distribution Points. Refer to figure 2-29.
WARNING
To prevent contamination of drinking water, make sure protective caps and plugs are installed
when components are not in use. Do not remove caps and plugs from components until
couplings are ready to be connected.
NOTES
Assembly of one distribution point is shown, the other is similar.
Refer to para 2-11d to connect quick disconnect couplings.
(1) Connect 4 inch female x 2 inch male adapter (2) to male discharge elbow(1) on 20K
collapsible fabric tank.
(2) Connect 2 inch x 10 feet suction hose (3) to 4 inch female x 2 inch male adapter (2).
(3) Position 125 gpm pump (4) in distribution point. Assemble and prepare 125 gpm pump (4)
for use (refer to the applicable TM).
(4) Connect 2 inch x 10 feet suction hose (3) to suction (inlet) port on 125 gpm pump (4).
(5) Connect 2 inch x 10 feet discharge hose (5) to discharge (outlet) port on 125 gpm pump (4).
(6) Position hypochlorination unit (7) in distribution point. Assemble and prepare
hypochlorination unit (7) for use (refer to the applicable TM).
NOTE
Use of adapters for connecting the hypochlorination unit will be determined by
the type equipment supplied with your system. Adapters may not be required.
(7) If required, connect 2 inch female x 1 1/2 male adapter (6) to inlet port of hypochlorination unit (7).
Connect 1 1/2 inch female x 2 inch male adapter (8) to outlet port of hypochlorination unit (7).
(8) Connect end of 2 inch x 10 feet discharge hose (5) to adapter (6).
(9) Connect 2 inch x 20 feet discharge hose (9) to adapter (8), if installed. If adapter is not
installed, connect hose to outlet port of hypochlorination unit (7).
(10)
Connect Y-fitting (10) to 2 inch x 20 feet discharge hose (9).
(11)
Connect 2 inch gate valve assembly (11) to Y-fitting (10).
(12)
Connect 2 inch x 20 feet discharge hose (12) to 2 inch gate valve assembly (11).
(13)
Connect Y-fitting (13) to 2 inch x 20 feet discharge hose (12).
2-60