TM10-5430-229-13&P
(2) Clean all metallic parts with a clean soft cloth or a medium bristle brush, and cleaning solvent. Be sure to
remove all gasket adhesive residue if gasket material is being replaced.
(3) Allow parts to dry.
c. Inspection. Inspect all metal parts for cracks, corrosion, or broken fittings.
d. Repair. Repair is limited to the replacement of parts found defective during inspection.
e. Assembly.
(1) Install gasket material (5), if removed. Refer to Appendix G for manufacturing instructions.
(2) Install washer (3) and turnlock (2) into end panel assembly (4).
(3) Install cross pin (1) into turnlock (2).
Figure 4-3. End Panel Assemblies Repair.
4-9