TM 10 5430-240-13&P 0018 00
0018 00-2
REPAIR
Repair any damage to the clamp assemblies by removing and repairing only one assembly at a time. The
right and left, top and bottom end clamps and handles must remain in the original location.
REPLACEMENT
NOTE
Use the following steps to replace the top and bottom center clamps or the top and
bottom end clamps. Top and bottom center clamps are shown.
1. Remove the cap screw (1) and flat washer (2) from top center clamp (3) and bottom center clamp (4).
2. Remove all burrs and sharp edges from the new clamps.
3. If either clamp is cracked or the bottom clamp threads are damaged, replace the clamp.
4. Install top center clamp (3) and bottom center clamp (4) on the tank.
5. Install cap screw (1) through the flat washer (2) and top center clamp (3), and thread it into the bottom
center clamp (4).
6. Torque the cap screws (1) to 70.0 } 5.0 ft-lbs (95 } 7 NEm).
END OF WORK PACKAGE
1
2
3
4