TM5-3820-256-10
2-40.
Pump Start-up.
WARNING
HAZARD VOLTAGE CAN CAUSE SEVERE INJURY OR DEATH. Switch must be off and contacts open
before contacting fuses or load end terminals. If contacts are not visible, use voltmeter to make sure no
voltage is present .
a.
Apply power to starter panel.
NOTE
Gate valve at wellhead should be open.
b.
Turn main power switch to ON (figure 2-54). Turn H-O-A switch to HAND position. Push START switch.
c.
Observe water discharge as pump operates. If pumping volume does not appear to be sufficient, stop
pump by turn H-O-A switch to OFF and perform following steps. Otherwise, proceed to d.
(1)
Turn main power switch to OFF.
Figure 2-54. Starter Panel Controls
2-120