Fig. 40 Positioning Discharge Fitting
Using tool SE-2838, tighten retainer ring to the
specified torque, Figure 41.
The base pump is now assembled. Check the
shaft to insure that it rotates freely and smoothly.
Fig. 42 Housing-to-Reservoir Gasket
Install a new pump housing-to-reservoir 0- ring in
the pump housing groove, Figure 42. Gasket
should be installed with color side out.
Prior to assembling reservoir on pump, install a
new filter element. The filter element is located
in the expansion neck of the reservoir, Figure 43.
Fig. 41 Tightening Retainer Ring
Fig. 43 Filter Element Location
Reservoir Expansion Neck
Oil Return Inlet Tube
CTS-4027 - Page 21
PRINTED IN UNITED STATES OF AMERICA