STAMPED ANGLE SPRING CLUTCH.
Observe the following notes and cautions when installing
Shift the transmission into gear
Check wear on fingers of clutch release yoke, cross
shaft and cross shaft bushings. Replace yoke, if
Be sure the transmission is square to and aligned with
the engine when it is raised Into position to maintain the
proper engine/transmission alignment.
Be sure the release bearing yoke clears the bearing and
is rotated over the wear pads as the transmission is
Align the splines by turning the transmission output shaft
Do not force the transmission into the clutch or flywheel
housing. If it does not enter freely, investigate the cause
of the problem.
Dont let the transmission drop or hang unsupported in
the driven discs Install transmission mounting bolts,
torque to proper specs and attach linkage. You are now
ready to adjust the clutch.
CTS-4195 Page 16