Figure 2-3. Water Distributor.
If engine does not start within 30 seconds, allow starter to cool 2
minutes before attempting to start engine again. Damage to starter
may occur if this caution is not followed.
When starting the engine from the auxiliary control box, the water
distributor engine cannot be heard. The tachometer will Indicate
that the engine is operating.
(4) Push the starter switch (9) until the engine starts.
(5) Adjust the engine idle speed with the throttle control (3). The idle speed should be 700-1000 rpm.
i. Adjust the throttle control (3) to approximately 2900 rpm and fill the water distributor tank.
j. When the water distributor tank is full, adjust the throttle control (3) to 700-1000 rpm.
k. Close the inlet valve (B, Figure 2-4).
Figure 2-4. Inlet Valve (B).