TM 5-3825-226-24
CYLINDER HEADS
4.
Install water sleeves into cylinder heads with tool
(A). Install the clamps on the water sleeves.
5.
Put the fuel line junction block in position and
install nut (3) to hold it.
6.
Install fuel lines (1) and (2) on the engine.
7.
Put alternator bracket (4) in position and install the
three bolts and washers to hold it.
8.
Install bolt (6) and the washer to hold the guide for
the oil level gauge.
9.
Put the gasket and plate (5) for the air compressor
in position on the timing gear cover and install the
four bolts and washers to hold it.
10.
Fill the cooling system with coolant to the correct
level.
end by:
a) install fuel injection nozzles
b) install rocker shafts and push rods
c) install fuel injection lines and air inlet manifold
d) install exhaust manifold
e) install belt tightener (water pump)
f) install air cleaner housing and panel assembly
g) install air compressor
h) install alternator
3-105