TM 5-3825-226-24
GOVERNOR AND FUEL INJECTION PUMP DRIVE
5.
Install tooling (B) into driven gear (5). Turn the
bolts evenly until gear (5) is free of the fuel
injection pump camshaft. Remove gear (5).
Remove tooling (B) from gear (5).
INSTALL GOVERNOR AND FUEL INJECTION PUMP
DRIVE
Tools Needed
A
3P1544
Timing Pin
1
1.
Put 5P960 Multipurpose Type Grease on the
dowels of the camshaft gear.
2.
Put drive gear (1) in position on the camshaft
gear.
3.
Install washer (2), the pin and the screw to hold
gear (1). Tighten the screw to 70 ± 5 lb.in. (8.0
± 0.6 N-m). Move the metal (stake) on the
outside face of gear (1) in two places around the
screw to hold it in position.
4.
Put gear (3) in position on the fuel injection
pump camshaft and install the washer and
sleeve (4) for the tachometer drive. Tighten the
sleeve to a torque of 11 ± 10 lb.ft. (149 ± 14 N-
m).
5.
Remove tool (A) and install bolt (5) and the seal
in the governor housing.
end by:
a) install timing gear cover and oil pump
3-122