OIL PUMP AND RELIEF VALVE
REMOVE OIL PUMP AND RELIEF VALVE
a) remove timing gear cover and oil pump
Bend the tabs of the locks from bolts (2).
Remove the bolts and cover (1) from timing
gear cover (3).
Loosen setscrew (4) and remove guide (5),
relief valve spring and plunger.
Remove inner rotor (6) and outer rotor (7) from
the timing gear cover.
Measure the inside diameter of bearing (8). The
inside diameter must be 2.804 ± .002 in. (71.22
± 0.05 mm). If a replacement of the bearing is
needed, put a mark on the timing gear cover as
to the location of the joint in the bearing and
remove the bearing.