Put the lower halves of mount assemblies (I) in
position on the tractor frame.
Put the gasket in position on the torque
Fasten a hoist to the engine and put it in
position on the tractor frame. Make sure the
gear teeth of the rotating housing in the torque
converter and the ring gear on the flywheel are
correctly engaged before the weight of the
engine is lowered on the frame.
CAUTION: Do not cause damage to the oil suction bell
assembly on the oil pump when the engine is installed.
Install the two drain hose clips (2), bolts (3) and
the washers that hold the torque converter to the
Install the sleeves and upper halves of mount
assemblies (I) in the engine rear supports.
Put brace assembly (4) in position on the left
rear engine mount and install bolts (5) and the
nuts in both engine rear mounts.