TM 5-3825-226-24
FLYWHEEL
(1)
Flywheel shoulder.
(2)
Install ring gear so that part No. is on this side. Ring gear must be
assembled against shoulder of flywheel.
NOTE: Do not heat ring gear to more than 400°F (2040°C before
installing on flywheel.
(3)
Pilot bore.
(4)
Torque for bolts holding flywheel to
crankshaft ................................ ...............55 ± 5 lb. ft. (75 ± 7 N.m)
Put 5P3413 Sealant on the bolt threads.
NOTE: Dash mark on flywheel must be in alignment with dash mark on
crankshaft.
1-28