Remove bearing (8) from the shaft with tooling
CAUTION: Bearing (8) will have damage when it is
removed. Use a new part for replacement.
Remove twenty-four bolts (9) and washers that
hold the impeller wheel to the rotating housing.
Install four 3/8 - 16 NC forcing screws in the
impeller wheel as shown. Tighten the screws
evenly until the impeller wheel (10) is loose and
can be removed from the rotating housing.
Turn the impeller wheel over. Remove six bolts
(13) and two plates (12). Remove guide wheel
assembly (stator) (11).
Turn the impeller wheel over. Install three 3/8 -
16 NC forcing screws in carrier (14). Tighten the
screws evenly until the carrier is loose. Remove