TM 5-3825-226-24
TORQUE CONVERTER
11.
Heat inner race (I ) to a temperature of
275°F (135°C). Install the race on the
shaft as shown until it makes contact with
the shoulder on the shaft.
12.
Install bearing (13) on the shaft. Heat
inner race (12) to a temperature of 275°F
(135°C) and install it on the shaft. Make
sure the race is pushed down as far as
possible.
13.
Temporarily install yoke (14) with two
bolts and washers.
14.
Turn the shaft around in the vise.
15.
Use tooling (C) to install sleeve (15) in the
carrier. Install the sleeve until it makes
contact with the counterbore in the carrier.
Make sure the tab on sleeve (15) fits in
the groove of the carrier.
3-168