Fasten a hoist to converter housing (32) and put
it in position over the rotating housing.
Install six bolts (34) that hold the converter
housing in position. Tighten the bolts to a
torque of 36 ± 2 lb. ft. (46 3 Nm).
Install flange (33), the O-ring seal, the retainer
and bolts that hold the flange in position.
Tighten the bolts that hold the flange to a torque
of 36 ± 2 lb .ft. (46 + 3 Nm).
Install transmission oil pump (35). Install the
four bolts that hold it. Connect the tube
assembly to the transmission oil pump.
hydraulic pump and the elevator hydraulic