REMOVE LOWER DRIVE SHAFT
1. Remove bolts (1) and (2) and the nuts that hold drive
shaft (3) in position. Remove the drive shaft.
INSTALL LOWER DRIVE SHAFT
1. Put drive shaft (1) in position on the machine.
Tighten the eight bolts and four nuts to a torque of 120 ±
10 lb. ft. (160 ± 14 Nm).
REMOVE UPPER DRIVE SHAFT
a) remove transmission and transfer gears
Remove the four bolts that connect drive shaft
(1) to the torque converter and remove the drive
INSTALL UPPER DRIVE SHAFT
Install drive shaft (1) and tighten bolts (2) to a
torque of 45 ± 5 lb. ft. (60 ± 7 Nm). end by:
a) install transmission and transfer gears