INPUT TRANSFER GEARS
Install two 3/8 - 16 NC forcing screws in gear (15)
and remove bearing 910).
Remove the ring that holds the bearing cups apart
from cage assembly (14).
Use tooling (A) and remove the inner and outer
bearing cups from cage assembly (14).
ASSEMBLE INPUT TRANSFER GEARS
Heat bearing cone (2) in oil to a maximum
temperature of 275°F (135°C) and install the
bearing on the output gear (1).
Install the ring that holds the bearing cups apart in
cage assembly (3).
Lower the temperature of the inner and outer
bearing cups and install them in cage assembly