INPUT TRANSFER GEARS
Install gear (6) in the case assembly. Make sure
the teeth of hear (6) and the output are engaged.
Install the spacer on gear (6).
Install the ring that holds the bearing cups apart in
Lower the temperature of the inner and outer
bearing cups (8). Install the bearing cups in cage
Install the O-ring seal on cage (9) and install cage
(9) in the cage assembly.
Heat the outer bearing cone in oil to a maximum
temperature of 275°F (135°C). Install the bearing
cone on input gear (6).
Use a press and a 2¾ x ¾ drive socket to install
seal (10) in the case assembly with the seal case
even with the case assembly and the seal lip
toward the inside as shown.
Install flange (12), the washer and bolt (11).
Tighten the bolt to a torque of 80 ± 5 lb. ft. (110 ±
connection of input transfer gears to