Install ring (105) to hold the No. 1 clutch in
Install the O-ring seals on sleeve (106).
Install sleeve (106) and ring (107) so the sleeve
is pushed all the way into the output transfer
gear case for installation of the valve manifold.
Make sure the five O-ring seals (108) are in
position on the transmission.
Install manifold (109) and tighten the four bolts
(110) to a torque of 35 ± 3 lb. ft. (45 ± 4 N.m).
Push sleeve (106) up into manifold (109) and
install ring (107) to hold the sleeve in position.
HYDRAULIC CONTROL VALVES to assemble
the selector and pressure control valves.
When selector valve (111) is installed the
valve spools must be held in position
because they are free to fall out and be
Put selector valve (111) in position and install
approximately 7 in. (17.8 cm) long to hold the
Put levers (115) in position. Make sure that the
levers are engaged with the valve spools and
push shafts (113) and (114) into levers (115).
Install the bolts that hold the levers to the shafts
and tighten them to a torque of 35 ± 3 lb. ft. (45
± 4 Nm).