TM 5-3825-226-24
TRANSMISSION HYDRAULIC CONTROL VALVES
ASSEMBLE TRANSMISSION HYDRAULIC
CONTROL VALVES
1. Assemble the selector valve as follows:
a) Make sure all of the parts of the selector control valve
are clean and free of dirt. Put clean SAE 30 oil on the
parts of the selector valve.
b) Install the plunger, spring, washer and ring in relief
valve assembly (2).
c) Install relief valve assembly (2) in the valve body.
Install the cover and tighten the bolts to a torque of 22 ±
3 lb. ft. (30 ± 4 N.m).
d) Install speed selector valve spool assembly (1) in the
valve body.
e) Install directional valve spool (3).
f) Make a replacement of the O-ring seals on detent
assemblies (5) if necessary. Install the detent
assemblies (4).
g) Install the setscrew and lock in hole (5).
h) Install speed selector valve spool (6).
j) Make a replacement of the O-ring seals on detent
assemblies (7) if necessary and install the detent
assemblies.
k) Install stop (9), the two washers and bolt(8).
3-217