Lower the temperature of bearing cup (8) and
install it in gear (7) from the large gear side of
Install the O-ring seal, bearing cone (9) and the
spacer on shaft (11).
Install the bearing cone in gear (7) from the
larger gear side.
Put gear (7) and the bearing cone in position in
the case assembly. Hold the gear and use four
3/8"- 16 NC x 6 in. (15.2 cm) long guide bolts to
install shaft (11). Tighten the bolts to hold the
shaft in position.
Use tool group (A) and install the lip type seal in
cage (12) with the lip of the seal toward the
inside of the cage.
Install O-ring seal (14) on cage (12).
Lower the temperature of bearing cup (13) and
install it in cage (12).
Install cage (12) and the original shims in
opening (10) on the output transfer gears case.