DIFFERENTIAL AND CARRIER ASSEMBLY (LOCK TYPE)
Make a replacement of the thrust
washers for the side gears and the
thrust washers for the pinions as a
Install pinions (10) and thrust washers (I 1) on
spider (9) as shown.
Install spider (9) in case (3).
Install side gear ( 3) and thrust washer (12) with
the groove in the washer next to the gear.
Heat bearing cone (14) in oil to a maximum
temperature of 275°F (135°C) and install it on
Put case (15) in position on case (3) with the
mark on case (15) in alignment with the mark on
Install the bolts, nuts (16) and cotter pins that
hold the differential cases together.
Install bolts and washers. Tighten bolts to 89 to
111 lb-ft (120 to 150 Nm) torque.