HYDRAULIC TANK OIL FILTERS AND HOUSING
Disconnect tubes (4) and (5) from the housing
found through the opening shown.
Remove bolts (6) that hold housing (7) to the
Lower the housing straight down until it can be
turned and removed between the inside of the
tire and the tractor frame.
After the housing is removed, check the ends of
tubes (4) and (5) under the fender for the
condition of the O-ring seals. If the seals have
damage, use new parts for replacement.
INSTALL HYDRAULIC TANK OIL
FILTERS AND HOUSING
1. Put housing (2) in position and install bolts (1).
Make sure the O-ring seals are in position on
the tube assemblies and install bolts (3) to hold
them to the filter housing.
Install panel (4), filters (5) and the valve
With the plug to the top, hold the cover and
tighten the bolts. Tighten the bolt to a torque of
60 ± 5 lb. ft. (80 ± 7 Nm).