Pull the tube and lower bearing (3) into position
in the draft frame with tooling (C) until the
bearing is even with the bottom surface of the
Use tool group (D) and a press to install
bearings (6) in link assembly (5).
Put link assembly (5) and the shims in position
on the hitch. Install shaft (7), plate (4) and the
Put link assembly (8) and the shims in position
on the draft frame.
Install shaft (10), plate (9) and the bolts.
Install the fitting in the bottom of shaft (10).
Put shims (13) as needed and steering cylinder
rod (12) in position and install shaft (11). Install
the plate and bolts to hold shaft (11) and install
the fitting in the bottom of the shaft.
Put clean grease in the fittings for the steering