LOAD TRANSFER CYLINDER
REMOVE LOAD TRANSFER CYLINDER
Start the engine, and lower the load transfer
axle. Stop the engine.
Disconnect the load transfer axle cylinder eyes
from the lugs on the axle. Start the engine,
retract the cylinders, and stop the engine.
Disconnect two hoses; one from the dump and
lift valve, and one from the fitting under the
walkplate near the right front fender.
Attach jumper hose to fitting under walkway and
to dump and lift valve.
NOTE: Attach hoist to cylinder before removing
bolts (1), washers (2) and cap (3).
Remove four bolts (1), washers (2), cap (3) and
bearings. Remove cylinder.