TM 5-3825-229-14&P
4-18. LICENSE PLATE LIGHT
THIS TASK COVERS:
a.
Removal
c.
Assembly
b.
Disassembly
d.
Installation
INITIAL SETUP:
Equipment/Materials Required:
Tools Required:
Conductor Splices (NSN 5940-01-079-1375)
(Item 21, Appendix E)
Nomenclature:
Equipment Conditions:
General Mechanics
Tool Kit
Ref
Conditions
2-23 Intervehicular cable disconnected.
a. Removal.
(1)
Remove two screws (1) holding light assembly (2) to rear fender.
(2)
Gently pull light assembly (2) and wires (4) away from fender.
(3)
Cut wires (4) on both sides of crimped wire connector and remove light assembly (2) and
gasket (3).
b. Disassembly.
(1)
To remove lens (5), insert screwdriver
blade fully under lens flange. Pry carefully
at several points if necessary.
(2)
Remove pre-formed packing (6) from
groove in housing (7).
(3)
Remove lamp (8) from socket (9).
c. Assembly.
(1)
Install lamp (8) in socket (9).
(2)
Install pre-formed packing (6) in groove
in housing (7).
(3)
Install lens (5).
4-37