TM 5-3825-229-14&P
4-19. IDENTIFICATION LIGHTS (cont)
a. Removal.
(1)
Disconnect tube (10), connector (9) and adapter (8) from housing (3). Lift tube from clamp
(7). Pull wires from housing and cut wires.
(2)
Remove six screws (6) and remove light assembly and gaskets (1I) from bar at top of tank.
(3)
To remove lenses (1) insert screwdriver blade fully under lens flange. Pry carefully at separate
points to remove lens if necessary.
(4)
Remove pre-formed packings (2) from grooves in housing (3).
(5)
Remove lamps (4) from sockets (5).
b. Installation.
(1)
Install lamps (4) in sockets (5).
(2)
Install pre-formed packings (2) in grooves in housing (3).
(3)
Install lenses (1).
(4)
Install gaskets (1 1) and light assembly on bar at top of tank and secure to bar with six screws
(6).
(5)
Connect wires from harness to lamp wires with conductor splices.
(6)
Install adapter (8) in housing (3) and connect tube (10) and connector (9) to housing. Install
tube in clamp (7).
4-20. 12- AND 24-VOLT RECEPTACLES
THIS TASK COVERS:
c.
Installation
d.
Fuse Replacement
a.
Test
b.
Removal
Equipment/Materials Required:
INITIAL SETUP:
Tags (Item 14, Appendix E)
Tools Required:
Equipment Conditions:
Nomenclature:
Ref
Conditions
General Mechanics
2-23 Intervehicular cable disconnected.
Tool Kit
4-22 Battery cables disconnected
WARNING
Electrical shock hazard exists. Disconnect battery cables (para. 4-22).
4-39