TM 5-3825-229-14&P
4-60 LINES AND FITTINGS (cont)
a.
Removal (cont).
(6) Remove two exhaust elbows (1 6). Remove solenoid valves (7). Remove nipples (1 7), bushings (18),
valves (19) and nipples (20).
(7)
Remove tee (21), nipple (22), elbow (23) and bushing (24) from spray valve (14).
(8)
Remove valve (26) and nipples (25) from spray valve (14). Remove spray valves (14) from discharge
header. Remove drain valves (67) from spray valves.
(9)
Remove cap (27) and adapter (28) to remove strainer (29) from suction tee (30).
(10)
Loosen hose clamps (31 and 32) and disconnect
hose (33) from nipple (34) and suction line (35).
Remove hose clamps and nipple (34).
(11) Remove eight nuts (36), washers (37) and screws (38) and remove suction butterfly valve (39) from
suction tee (30) and suction line (35). Remove suction tee (30) from pump (65).
(12) Support suction line (35) with blocking and remove two nuts (40) and U-bolt (41) from brace (50).
(13) Remove two nuts (42) and screws (43). Separate clamps (45) and disconnect suction line (35) from
suction elbow (36). Remove gasket (44).
(14) Remove two nuts (46) and screws (47). Separate clamps (48) and disconnect suction elbow (36) from
outlet at bottom of tank. Remove gasket (49) and suction elbow.
(15) Remove four nuts (51), washers (52) and screws (53) and remove pipe adapter (54) and fill butterfly
valve (55). Remove elbow (56) from adapter.
(16) Remove two nuts (66) and U-bolt (57) from brace (58).
(17) Remove eight nuts (59), lockwashers (60) and screws (61). Remove discharge header (62) from
discharge flange (64). Remove gasket (63). Remove discharge flange (64) from pump (65).
b.
Installation.
NOTE
Use pipe sealant (Item 1 1, Appendix E) on threads of all water pipes before installation.
(1)
Screw discharge flange (64) into outlet of pump (65).
(2)
Place new gasket (63) and discharge header (62) in position on discharge flange (64). Secure header
to discharge flange with eight screws (61), lockwashers (60) and nuts (59).
(3)
Slide U-bolt (57) over discharge header (62) and through holes in brace (58). Secure U-bolt (57) with
two nuts (66) to support discharge header.
4-135