4-10. HOSE ASSYS, REPAIR (CONT).
For reassembly use clamping tool, P/N C001 (70847 supplied with
the system kit
Push male coupling (4) and/or female coupling (9) into hose (1).
Cut a band of strapping that will extend 8 to 10 inches beyond end
of buckle toothed slot.
Hook the band over top of buckle between the prongs (4) bringing
over end around hose and thrugh buckle.
Insert band end into tool slots. Nose of tool should fit snug
against buckle (5).
Apply tension on tool handle and gripper lever and position as
required. Tool will self-lock when proper tension is applied (6).
Band may break if operator releases tension handle before backing off entire length of bend.
Change 2 4-9