The 125 GPM pump is normally issued equipped with two each two-inch 11-1/2
NPT X 11-1/2 NPSH hose adapters. Before starting to assemble the 125 GPM
pump connection kit, check the pump to be sure that these fittings have been
replaced with one each coupling half, male quick disconnect (96906) MS27022-
11 on the discharge side and one each coupling half, quick disconnect, female
(96906) MS27021-11 on the suction side.
2-9.3.6 125 GPM Pump Connection KitInput Flow Side. Perform the following after the 350 GPM
pump connection kit has been completely set up on input side of system, as described in paragraph 188.8.131.52.
See TM 5-4320-208-12/20P.
a. Remove protective cap from male quick-disconnect on tee assy (17) on the 350 GPM pump connection
b. Connect reducer (20) to tee assy (17).
Change 2 2-41