SECTION III. TOOL AND TEST EQUIPMENT REQUIREMENTS
TOOL OR TEST
Tool Kit, General Mechanics
Torque Wrench 0-200 inch
SECTION IV. REMARKS
Remove sand or snow.
All tanks will be tested semiannually as follows:
1. Inflate tank air pressure and allow it to stand for 30 minutes.
2. Apply a water and detergent solution generously to all seams and fittings.
3. Any evidence of air leakage will cause the tank to be considered to be defective.
Repair by replacing defective components.
Cap must open at pressure of 3 inches of water.
Temporary repairs are made by Organizational Maintenance and permanent repairs by Direct