TM 5-5430-211-13 & P
Place the coupling half (10), the
composition gaskets (11), oval
closure plate (12) and suction stub
(13) so that their holes are
aligned. Coat the bolts (8),
washers (14) and nuts (15) with a
thin film of epoxy-polyamide
Replace a 1.5 inch bolt (8) with
thread seal (9) through one of the
Put the lock washer (14) on the
Put the nut (15) on the bolt a few
Replace the other bolts, seals,
washers and nuts.
Tighten all bolts finger tight only.