Figure F-1.
TM 10-4130-237-14
APPENDIX F
ILLUSTRATED LIST OF MANUFACTURED ITEMS
F-1.
SCOPE. This appendix includes complete instructions for making items authorized to be manufactured or fabri-
cated at unit maintenance. A part number index in alphanumeric order is provided for cross-referencing the part number
of the item to be manufactured to the figure which covers fabrication criteria All bulk materials needed for manufacture
of an item are listed by part number or specification number in a tabular list on the illustration.
PULLER ADAPTER MES 90-0001
1. Connect predrilled pipe Coupling and pipe nipple.
2. Place puller adapter overdrive hub assembly and align 0.281” hole in adapter with hole in drive hub assembly.
3. Thread bolt through puller adapter into hole in drive hub assembly. Bolt should extend 1/2” to 3/4” into drive hub
assembly.
4. Using a standard two or three jaw puller, remove drive hub assembly from shaft.
F-1
