TM 10-4320-303-13
a. Remove two bolts (Figure 4-7, 1) and tie bar (2) from flaking box assembly (3).
b. Remove and discard four cotter pins (4).
c. Remove four clevis pins (5) and clevises (6) from flaking box assembly (3).
d. Remove tailgate assembly (7) from flaking box assembly (3).
4.11.2.2 Inspection and Cleaning.
a. Inspect tie bar (2), flaking box assembly (3), clevis pin (5), clevis (6), and tailgate assembly (7) for
corrosion, cracks, bends, and damage.
b. Inspect two bolts (1) for corrosion and damage.
WARNING
Dry cleaning solvent used to clean parts is potentially dangerous to personnel
and property. Avoid repeated or prolonged skin contact. Do not use near open
flame or excessive heat. Flash point of solvent is 100-138 degrees Fahrenheit
(38-60o C).
Wear goggles and gloves when using cleaning solvent,
Failure to obey these warnings may result in death or personal injury.
c. Clean two bolts (1), tie bar (2), clevis pin (5), and clevis (6) which are not damaged.
d. Allow cleaned components to thoroughly air dry.
4.11.2.3 Repair. Repair of flaking box assembly (3) consists of replacing damaged or defective components.
Notify Direct Support Maintenance for welding.
4.11.2.4 Assembly.
a. Insert tailgate assembly (7) into flaking box assembly (3).
b. Align mounting holes of four devises (6) with clevis mounting holes on flaking box assembly (3).
c. Install four clevis pins (5) and new cotter pins (4).
d. Align mounting holes of tie bar (2) with tie bar mounting holes of flaking box assembly (3).
e. Install two bolts (1). Tighten bolts (1).
4-23
