TM 10-4320-345-13
CHAPTER 3
OPERATOR MAINTENANCE INSTRUCTIONS
Section I.
Lubrication Instructions..................................................................................................
3-1
Section II.
Operator Troubleshooting..............................................................................................
3-1
3-1.
Introduction ................................................................................................................
3-1
3-2.
Malfunction Index.......................................................................................................
3-2
3-3
Troubleshooting Table................................................................................................
3-2
Section III.
Operator Maintenance Procedures................................................................................
3-26
3-4
Component Replacement (Quick Disconnect Couplings)............................................
3-26
3-5
Quick Disconnect Coupling Repair.............................................................................
3-28
3-6
Component Replacement (Coupling Clamps).............................................................
3-30
3-7
Coupling Clamp Repair ..............................................................................................
3-34
3-8
Hose (6-inch) Repair ..................................................................................................
3-35
Section I. LUBRICATION INSTRUCTIONS
Lubrication of the Tactical Water Distribution System is limited to the 600 gpm and 125 gpm pumps.
Lubricate this equipment in accordance with the applicable technical manual.
Refer to the applicable TM for lubrication requirements on the 600 gpm pumps.
Refer to the applicable TM for lubrication requirements on the 125 gpm pumps.
Section II. OPERATOR TROUBLESHOOTING
3-1. INTRODUCTION.
a.
The troubleshooting table lists the common malfunctions which you may find during operation of the
water system. You should perform the tests, inspections and corrective actions in the order they appear
in the table.
b.
This table cannot list all the malfunctions that may occur, all the tests or inspections needed to find the
fault, or all the corrective actions needed to correct the fault. If the equipment malfunction is not listed
or actions listed do not correct the fault, notify your supervisor.
c.
Refer to the applicable TM for troubleshooting malfunctions on the 600 gpm pumps.
d.
Refer to the applicable TM for troubleshooting malfunctions on the 125 gpm pumps.
e.
Refer to the applicable TM for troubleshooting malfunctions on the hypochlorination units.
f.
Refer to the applicable TM for troubleshooting malfunctions on the 20K collapsible fabric tanks.
3-1
