TM 10-4320-345-13
4-25. FLAKING BOX ASSEMBLY MAINTENANCE.
The flaking box assembly consists of the components listed below Refer to the following paragraphs for
applicable maintenance procedures.
Procedure
Para.
Flaking Box Repair ................................................................................................................................ 4-26
Discharge Hose (6-Inch) Repair............................................................................................................. 4-17
4-26. FLAKING BOX REPAIR.
This task consists of:
a.
Disassembly
b.
Cleaning
c.
Inspection
d.
Repair
e.
Assembly
INITIAL SETUP :
Tools:
Material/Parts:
General Mechanics Tool Kit (Item 1, App B)
Detergent, General Purpose (Item 1, App E)
Equipment Condition :
Wiping Rag (Item 2, App E)
Hoses removed or deployed
Cotter Pin (Item 25, App I)
NOTE
Ensure that all parts identified as mandatory replacement parts are discarded and replaced with
new components.
a.
Disassembly. Refer to figure 4-16.
(1)
Remove cotter pin (1) from clevis pin (2).
(2)
Remove clevis pin (2) from bracket (4).
(3)
Separate clevis (3) from bracket (4).
(4) Repeat steps (1) through (3) for three remaining brackets (4).
b.
Cleaning.
(1)
Wash flaking box interior and exterior with clean water and detergent.
(2)
Rinse flaking box with clean water and dry with wiping rag.
c.
Inspection.
(1)
Inspect interior and exterior of flaking box (5) for cracks, broken welds and bent or crushed frame
members.
(2)
Inspect clevis, (3), clevis pins (2) and brackets (4) for cracks and signs of wear.
d.
Repair. Replace damaged or defective components
4-58
