TM 10-4610-242-13
2-10. ASSEMBLY AND PREPA RATION FOR USE: - cont.
i.
Assemble 125 GPM Pump Assembly Connection Kit (Water Source). Refer to figure 2-16.
WARNING
To prevent contamination of drinking water, make sure protective caps and plugs are installed
when components are not in use. Do not remove caps and plugs from components until
couplings are ready to be connected.
NOTES
·
Install all gate valves with hand wheel in upright position and valve fully closed.
·
Suction hoses are noncollapsible and discharge hoses are collapsible.
·
With exception of two adapters, all couplings in this kit are 2-Lnch diameter.
(1)
Connect adapter (4-inch female x 2-inch male) (2) to tee (1) from 350 gpm pump connection kit.
(2)
Connect 20 root suction hose (3) to adapter (2).
(3)
Connect 2-inch gate valve (4) to 20 foot suction hose (3).
(4)
Connect 20 foot suction hose (5) to 2-Lnch gate valve (4).
(5)
Assemble and prepare 125 gpm pump (6) for use. Refer to the applicable TM.
(6)
Position 125 gpm pump (6) in water system.
(7)
Connect end of 20 foot suction hose (5) to female (suction) coupling (7) on pump (6).
(8)
Connect 20 foot discharge hose (9) to male (discharge) coupling (8) on 125 gpm pump (6).
(9)
Connect check valve (10) to 20 foot discharge hose (9).
(10)
Connect 2-inch gate valve (11) to check valve (10).
(11)
Connect 20 foot discharge hose (12) to 2-inch gate valve (11).
(12)
Connect adapter (4-inch male x 2-inch female) (13) to tee (14) from 350 gpm pump connection kit.
(13)
Connect end of 20 foot discharge hose (12) to adapter (13).
2-46
