TM 10-4610-243-13
4-38.
TEE AND GATE VALVE ASSEMBLY (9114-Y5) REPAIR - cont.
d.
Repair.
(1) Refer to para. 4-31 to repair gate valve.
(2) Replace defective components. Do not reuse scaling components.
e.
Assembly. Refer to figure 4-35.
(1) Position gasket (37) and female coupling (36) on tee (38).
(2) Install eight flat washers (35), screws (34), flat washers (33) lockwashers (32) and nuts (31).
NOTE
Ensure gasket is fully seated in groove of coupling.
(3) Install gasket (30) in female coupling (36).
(4) Connect plug (29) to female coupling (36) with ring (28).
(5) Position gasket (27) and male coupling (26) on tee (38).
(6) Install eight flat washers (25), screws (24), flat washers (23), lockwashers (22) and nuts (21).
NOTE
Ensure gasket is fully seated in groove of cap.
(7) Install gasket (19) in cap (20) Connect cap to male coupling (26) with ring (18).
(8) Position gasket (17) and gate valve (16) on tee (38).
NOTE
Two flat washers must be installed under heads of both top attaching screws when installing gate
valve. Refer to Figure 4-27 for position of screws and double washers.
(9) Install ten flat washers (15), eight screws (14), flat washers(13) lockwashers(12) and nuts (11).
(10) Position gasket (10) and female coupling (9) on gate valve (16).
(11) Install ten flat washers (8), eight screws (7), flat washers (6), lockwashers (5) and nuts (4).
NOTE
Ensure gasket is fully seated in groove of coupling.
(12) Install gasket (3) in female coupling (9).
(13) Connect plug (2) to female coupling (9) with ring (1).
4-106
