TM 10-8110-202-13&P(3)ITEM column. The item number identifies the item associated with the figure listed in the adjacent FIG.column. This item is also identified by the NSN listed on the same line.b.PART NUMBER INDEX. Part numbers in this index are listed by part number in ascending alphanumericsequence (i.e., vertical arrangement of letter and number combination which places the first letter or digit of each group inorder A through Z, followed by the numbers 0 through 9, and each following letter or digit in like order).(1)FSCM column. The Federal Supply Code for Manufacturer (FSCM) is a 5-digit numeric code used toidentify the manufacturer, distributor, or Government agency, etc., that supplies the item.(2)PART NUMBER column. Indicates the primary number used by the manufacturer (individual, firm,corporation, or Government activity), which controls the design and characteristics of the item by means of itsengineering drawings, specifications, standards, and inspection requirements to identify an item or range ofitems.(3)STOCK NUMBER column. This column lists the NSN for the associated part number and manufactureridentified in the PART NUMBER and FSCM columns to the left.(4)FIG. column. This column lists the number of the figure where the item is identified/located in Sections IIand Section III.(5)ITEM column. The item number is that number assigned to the item as it appears in the figure referenced inadjacent figure number column.C-5.SPECIAL INFORMATION.USABLE ON CODE. The usable on code appears in the lower left comer of the Description column heading.Usable on codes are shown as "UOC:" in the Description Column (justified left) on the last line applicable itemdescription/nomenclature. Uncoded items are applicable to all models. Identification of the usable on codes used in thisRPSTL are:CodeUsedOnDURModel RD610EUZModel M43699-02FLZModel GTA/WD500-S/01C-6.HOW TO LOCATE REPAIR PARTS.a.When National Stock Number or Part Number Is NOT Known.(1)First. Using the table of contents, determine the assembly or subassembly group to which the item belongs.This is necessary since figures are prepared for assembly groups and subassembly groups, and listings aredivided into the same groups.(2)Second. Find the figure covering the assembly group or subassembly group to which the item belongs.Change 5 C-7
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business