Figure 4-33. Crown Block AssemblyCAUTIONWhen the shaft (4) is removed, the sheave (5) is free to fall. Take precautions to preventinjury.b.Use a pry bar in the lockplate slot of shaft (5) to being removal. Remove shaft (5) and sheave (6) from crownblock.c.Place sheave (6) on workbench and press out bearings (7).d.Install new bearings (7) so that they are flush on each side of sheave (6).e.Place sheave (6) in position on crown block frame and install shaft (5).f.Install lockplate (4) in shaft slot and install screws (2) and lockwashers (3). Install grease fitting (1).4-13.1.2 Third Drum Sheaves.a.Remove grease fitting (8), screws (9), lockwashers (10) and lockplate (11).CAUTIONWhen the shaft (12) is removed, the sheave (4) is free to fall. Take precautions to preventinjury.b.Use a pry bar in the lockplate slot of shaft (12) to begin removal. Remove shaft (12).4-147
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
