c.
Install assembled shaft (82) in case and seat the bearing (79) in retainer (77). Install the seal (84) in retainer (73)
and install the retainer (73) and gasket (74) over the shaft (82). Install screws (71) and lockwashers (72).
d.
Rotate shaft to make sure the bearings are not binding. Install key (70), flange (69), nut (68) and cotter pin (67).
e.
Install key (61) in shaft (58) and install sprocket (60). Press bearings (59 and 57) onto shaft (58).
f.
Install adapter (65) and gasket (66) in case (85) and secure with screws (63) and lockwashers (64).
g.
Install assembled shaft (58) and seat the bearing (57) in adapter (65). Install the seal (62) in retainer (55) and
install the retainer (55) and gasket (56) over shaft (58). Install screws (53) and lockwashers (54).
h.
Rotate the shaft (58) to make sure the bearings are not binding. Install key (47).
i.
Press the bearing (49) into hub (46) and install snap ring (48). Assemble drive ring (52) to hub (46) and install
screws (50) and lockwashers (51).
j.
Install the assembled hub (46) on shaft (58) and tighten setscrews (45).
k.
Press bearing (44) into adapter (39) and install snap ring (43). Install sprocket (42) in adapter (39) and bearing
(44), and install snap ring (41).
I.
Install the adapter (39) and gasket (40) on case (85) and install screws (37) and lockwashers (38).
m.
Press bearing (30) onto shaft (29), then install shaft and bearing in retainer (21).
n.
Install key (28), sprocket (27), spacer (26), key (25) sprocket (24) and sprocket (23) on shaft (29).
o.
Install the retainer (21), with shaft assembly, and gasket (22) in case (85). Install seal (19) in retainer (18) and
install retainer and gasket (20) over shaft (29). Install screws (16) and lockwashers (17).
p.
Install seal (36) and bearing (35) in retainer (33). Install the retainer (33) and gasket (34) over shaft (29) and
install screws (31) and lockwashers (32).
q.
Rotate shaft (29) to be sure bearings are not binding. Install key (15), flange (14) and tighten setscrews (13).
r.
Install and connect chains (10,11 and 12).
s.
Install gaskets (9 and 5), plates (8 and 3), screws (6) and lockwashers (7).
NOTE
Make sure that plate (3) is installed with filler cap (4) in original position, or case will not fill
with lubricant properly.
4-52