fit in the recessed area of the pressure plate. Insert the friction disc (1 7) into _ the housing.
n.
Position the gasket (5) on the bearing container (26) and slide the housing (4) with spring assembly (9), pressure
plate (16) and friction disc (17) over the shaft and into position.
o.
Install the screws (2) and washers (3) and tighten each one alternately to press the bearing cup (48) into position.
p.
Slide thrust ring (38) over the drum shaft (30) and install cover (35) with new gaskets (36) and o-ring (37).
q.
Install screws (34) to draw the cover up tight against housing (45). Install and tighten screws (32) and washers
(33) through the cover side brackets.
r.
Slide the spacer (31) over the shaft and install keys (29). Start the end of the key closest to the cover and then
rap the other end sharply with a plastic mallet.
5-7.1.5 Installation. (Figure 5-6)
a.
Support winch drum (1) in position. Be sure that keyway in drum alines with keys (9) in winch shaft.
b.
Slide the winch assembly (8) into position on turret and install screws (7). Tighten setscrew (6).
c.
Assemble motor (5) to winch assembly (8) and install screws (4). Apply thread sealer on threads of hydraulic
hoses and connect them to motor (5).
d.
Fill winch with gear oil then operate winch in and out several times to purge air.
5-7. 2 Winch Motor. (Figure 5-8)
5-7.2.1 Disassembly. Prior to removing roller stator motor from unit, clean off all dirt. Disconnect hydraulic connections
and plug ports. Remove the motor from unit. After removal, wash the motor with solvent to remove all excess dirt from
outside of the motor. Remove the woodruff key from shaft (11), place the motor in a vise taking care to clamp at port
area of housing. Place newspapers or a sheet of cardboard on top of bench to obtain a clean work area.
a.
Remove four bolts (18) (9/16 socket or boxed end).
b.
Shift wear plate to clear end of drive link and lift group [end cover (17), rotor assembly (15) and wear plate (13)J
from housing assembly (5).
c.
Remove shaft (11) and drive link (12) from housing by pushing up on shaft end ½ Y with palm of one hand
and lifting shaft with the other hand. Items 6, 7, 8, 9, 10, 11, 12 and 16 usually will come out from assembly.
5-18
