SERVICE MANUAL
INTRODUCTION
Introduction
SPECIAL NUT AND BOLT TORQUE DATA*
(Continued)
N•m
Ibf-ft**
Injection High Pressure Connectors........................................................................................... 40
30
Injection Nozzle Holder Nut (with Nozzle Installed).................................................................... 45
33
Intake Manifold Bolt.................................................................................................................... 27
20
Oil Filter By-Pass Valve Cap ..................................................................................................... 68
50
Oil Pan Drain Plug...................................................................................................................... 45
33
Oil Pan Bolts .............................................................................................................................. 27
20
Oil Pressure Regulating Valve Cap Nut .................................................................................... 230
170
Turbocharger Mounting Bolts .................................................................................................... 47
35
Tachometer Drive Thrust Plate Nuts .......................................................................................... 27
20
Valve Adjusting Screw Nut ......................................................................................................... 27
20
Vibration Damper Mounting Bolts
............................................................................................................................................. 47
35
Water Pump Hub Nut (Nut Retained Hub) ................................................................................ 203
150
(Regular
Nut) †
237
175
(Flanged
Nut) ††
†Use Loctite #242
††Use Oil
* All torques are given with bolts, studs and nuts lubricated with SAE 30 engine oil or chassis grease, except as noted.
**Unless otherwise noted
CGES-185-3
PRINTED IN UNITED STATES OF AMERICA
Page 32
