CONTROLSSECTION IIIRemote ControlDisassembly1.Remove the six capscrews and lockwashers.Separate the remote control from the shifterhousing.2.Remove the setscrew from the universal jointassembly, and pull the universal joint from therod.3.Remove the four capscrews and lockwashersthat hold the end cover and gasket in place.4.Remove the setscrew from the joint shift rodfinger. Tap the rod through the cross holes inthe housing.5.Remove the finger from the housing.6.Remove the setscrew from the inner shift finger.7.Slide the rod and bracket assembly from theinner shift finger. Be careful not to lose the key.8.Remove the seals from the cross holes in thehousing.InspectionCheck the shift fingers for excessive wear. Also checkall bores and rods for excessive wear or scuffing.Clean all parts thoroughly, and apply a light coat ofgrease to the pivot points when reassembling.Reassembly1.Install a key in the rod and bracket assembly.Install the unit into the remote housing, slidingthe inner shift finger on the end of the rod.2.Line up the setscrew hole and install thesetscrew. Torque to 40-50 ft. lbs.3.Install the joint shift rod through the cross holesand the outer finger. Make sure the finger isinserted into the bracket.4.Align the setscrew hole and install the setscrew.Torque to 40-50 ft. lbs.5.Install the end cover, and secure it with the fourcapscrews and lockwashers.6.Install two new oil seals in the joint shift rodbores.7.Install the joint assembly and secure it with asetscrew.7
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
