(5) Remove control assemblies (18) and disconnect throttle cables (1 and 7) from injector pump.(6) Disconnect throttle cables (1 and 7) from bracket (8) and throttle controls.(7) Remove screws (10), lockwashers (9), and bracket (8) from engine. Discard lockwashers.(8) Remove circuit breaker (5) from air cleaner bracket.c. Installation (See Appendix E Figure 69).(1) Install circuit breaker (5) to air cleaner bracket.(2) Attach bracket (8) with screws (10) and new lockwashers (9).(3) Connect throttle cables (1 and 7) to bracket (8) and throttle controls.(4) Connect throttle cables (1 and 7) to the injector pump with control assemblies (18).(5) Connect solenoid (6) to bracket (8) with screws (4), new lockwashers (3), and nuts (2).(6) Temporarily connect connecting link (19), nut (20), and bracket (21) to solenoid (6).NOTEThe lever must be in the run position and there must be 1/16 in. (1.6 mm)clearance between the lever and the lever stop (see Figure 4-17).(7) Compress the solenoid (6) fully to bottom position and adjust connecting link (19) to the hose in the injectorpump lever.(8) Tighten nut (20) and repeat step (7) above as necessary.Figure 4-17. Throttle Control and Injector Pump.4-49. EXHAUST MUFFLER REPLACEMENT.a. Removal (See Appendix ,E Figure 73)._________WARNINGDo not attempt to remove any part of exhaust system until it has cooled. Failureto follow this warning may result in serious burns.(1) Remove top engine cowling.(2) Remove rain cap (2).(3) Remove nuts (7), washers (6), exhaust muffler (1), and gasket (4). Discard gasket.(4) Separate exhaust muffler (1) and flange (3).b. Installation (See Appendix F, Figure 73).(1) Attach flange (3) to exhaust muffler (1).(2) Attach exhaust muffler (1) and new gasket (4) to exhaust manifold with washers (6) and nuts (7).(3) Attach rain cap (2) to exhaust muffler (1).(4) Attach top engine cowling.TA5063284-39
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
