TM 5-3825-226-24
AIR COMPRESSOR
10.
Put cylinder block (14) in position on the
crankcase and install the six bolts that hold it.
11.
If necessary use a press and install a new bushing
in connecting rod (17). The new bushing must be
made larger with a reamer after it is installed.
12.
Put piston (16) in position on connecting rod (17)
and use a press to install pin (18). Make sure the
hole in the pin is in alignment with the hole in the
piston so the lockwire can be installed. Install
lockwire (19).
13.
Install bearings (15) in connecting rod (17).
14.
Install rings (20) on the pistons with the narrow
side of the rings toward the top of the piston.
15.
Put clean SAE 30 engine oil on the piston rings
and connecting rod bearings. Turn the crankshaft
so one of the connecting rod journals is in the
"DOWN" position. Install tool (B) over the piston
to put the piston rings under compression. Install
piston assembly in cylinder bore. Make sure the
connecting rod is over the crankshaft journal.
3-23
