TM 5-3825-226-24
FLYWHEEL HOUSING
REMOVE FLYWHEEL HOUSING
start by:
a)
remove starter
b)
remove flywheel
c)
remove oil pan
1.
Remove bolts (1) and the washers that hold the
flywheel housing to the cylinder block.
2.
Remove flywheel housing (2) and the gasket
from the cylinder block.
INSTALL FLYWHEEL HOUSING
1.
Clean the contact surfaces of the flywheel
housing and cylinder block. Install the flywheel
housing gasket on the cylinder block.
2.
Install a 3/8"-16 NC guide bolt (2) with a
minimum length of 4 in. in the cylinder block.
3.
Put clean engine oil on the lip of the crankshaft
rear seal. Put flywheel housing (1) in position
on the cylinder block and install the bolts and
washers to hold it.
4.
Cut the gasket so it is even with the bottom of
the cylinder block and flywheel housing.
end by:
a) install starter
b) install flywheel
c) install oil pan
3-140
