TM 5-3825-226-24
STEERING CONTROL VALVE
3.
Connect linkage (5) to the valve and install the
bolt, nut and cotter pin.
4.
Fill the hydraulic tank with oil.
DISASSEMBLE STEERING CONTROL VALVE
Tools Needed
A
B
1P3075
Puller Group
1
2P8312
Retaining Ring Pliers
1
start by:
a)
remove steering control valve
NOTE:
Check the condition of the O-ring
seals as the seals are removed. If the
seals have damage, use new parts
for replacement.
1.
Remove bolts (3) and cover (2) from body (1).
2.
Remove the two O-ring seals and the lip-type
seal from the inside of cover (2).
NOTE:
Remove
the
guide
pilot
for
replacement only.
3.
Remove plug (5) from cover (4). Remove the
shims, the spring and the pilot valve from
behind the plug.
NOTE:
Keep
the
shims
together
for
reference during installation.
4.
Remove bolts (6) and cover (4) from the body.
5.
Remove the four O-ring seals from cover (4).
6.
Remove spacer (8) from the body. Remove the
valve and two springs from behind the spacer.
7.
Remove O-ring seal (7) from spacer (8).
3-307
